General (1-1)

 A&P License 교재 중 FAA 에서 발행하는 General Textbook 입니다.

오늘부터 원본으로 올려보도록 하겠습니다.  기초적인 부분은 원본만 올리도록 하고 추가 설명이 필요한 부분만 따로 첨삭형태로 강의 진행하도록 하겠습니다. 

 

---

 

 

 

 

 

 

 

 

Mathematics in Aviation Maintenance

Mathematics is woven into many areas of everyday life.
Performing mathematical calculations with success requires an understanding of the correct methods and procedures, and practice and review of these principles. Mathematics may be thought of as a set of tools. The aviation mechanic will need these tools to successfully complete the maintenance, repair, installation, or certification of aircraft equipment.
Many examples of using mathematical principles by the aviation mechanic are available. Tolerances in turbine engine components are critical, making it necessary to measure within a ten-thousandth of an inch. Because of these close tolerances, it is important that the aviation mechanic be able to make accurate measurements and mathematical calculations. An aviation
mechanic working on aircraft fuel systems will also use mathematical principles to calculate volumes and capacities of fuel tanks. The use of fractions and surface area calculations are required to perform sheet metal repair on aircraft structures.

Whole Numbers
Whole numbers are the numbers 0, 1, 2, 3, 4, 5, and so on.
Addition of Whole Numbers Addition is the process in which the value of one number is added to the value of another. The result is called the sum. When working with whole numbers, it is important to understand the principle of the place value. The place value in a whole number is the value of the position of the digit within the number. For example, in the number 512, the 5 is in the hundreds column, the 1 is in the tens column, and the 2 is in the ones column. The place values of three whole numbers are shown in Figure 1-1.

 

 

 

 

When adding several whole numbers, such as 4,314, 122, 93,132, and 10, align them into columns according to place value and then add.

 

 

Subtraction of Whole Numbers
Subtraction is the process in which the value of one number is taken from the value of another. The answer is called the difference. When subtracting two whole numbers, such as 3,461 from 97,564, align them into columns according to place value and then subtract.